Model Number: ZZB000071
Usage: 3D printe
Type: MKS Gen V1.4 control board
Condition: New
Place of Origin: Guangdong,China(Mainland)

Features

• Arduino MEGA compatible Atmega2560 and FT232 processors are compatible with all RAMPS class firmware

• Firmware can use the same configuration as ramps1.4

• Easy DISPLAY + SD-CARD connector, RepRapDiscount SmartController compatible pin header on board
• Easy connect MKS TFT on AUX-1

• All extra pins broken out the same as ramps1.4(AUX-1,AUX-2,AUX-3,Servos1)

• 3x temperature ADC connectors for thermistors

• up to 5 motor driver with easy micro stepping setup (micro switches)

• 4x PWM capable power mosfet outputs with voltage selector for MainPower.(Bed,Extruder0,Extruder1, Fans)

• 4 layers PCB, optimize heat dissipation.
• 3*5V output, 3*12V output interface.
• 6x end stop connectors with power supply Xmin/Xmax/Ymin/Ymax/Zmin/Zmax

• Recoverable fuse for short-circuit protection.