FEATURES

· Lightweight, polymer shotshell carrier.

· Easy installation, requires no alterations to the shotgun in most cases.

· All mounting screws are included, no gunsmithing required

SPECIFICATIONS

Color: Black

Material: Military Grade Polymer

Available Range: Training, Competition, or Hunting Use

KIT

· two Allen Key of different size.

· a 10/32 screw with washer.

· a 1/4-28 screw with washer

INSTALLATION GUIDE:

1. : Remove 6 little hex screws from the shotshell carrier to expose two tapped hole in the mounting plate.

2: Lay the shotgun on its side with the ejection port facing down.

3. : Using the supplied big screw with washer, push out pin (A) located above and to the rear of the trigger guard. Leave screw in hole.

4: Turn the shotgun over and place the mounting plate on the receiver with the two corresponding holes on the two screws.

5: Start screws into the mounting plate and lightly tighten. Do not overtighten. Overtightening may lock up the shotgun’s action. To remedy, simply loosen screws.