Product Description
| Dimension | 45X145X210 mm |
| Weight | 2.86kg |
| Power Source | Pneumatic |
| Required pressure | 70-110PSI(4.8-7.5bar) |
| Max.Pressure | 120PSI (8.3bar) |
| Capacity | 100000 |
Feature:
Upholstery Stapler.
Uses: 1/4'' to 1/2'' 20-gauge staple;
Comfortable rubber soft grip;
Accepts 1013J Series Staples.
Air Nailer Trouble Shooting:
| Symptom | Problem | Solutions |
| Air nailer's leak near top of tool or in trigger area |
1.O-ring in trigger valve are damage 2. Air nailer's trigger valve head are damage 3.Air nailer's trigger valve stem, seal or O-ring are damaged |
1.Check and replace O-ring 2.Check and replace 3.Check and replace trigger valve stem, seal or O-ring |
| Air Nailer's leak near bottom of tool |
1.Loose screws 2.Worn or damaged O-ring or bumper |
1.Tighten screws 2.Check and replace O-ring bumper |
| Air leak between body and cylinder cap |
1.Loose screws 2.Worn or damaged O-ring or bumper |
1.Replace bumper 2.Adjust the air pressure |
| Blade driving fastener too deep |
1.Worn bumper 2.Air nailer pressure is too high |
1.Verify adequate air supply 2.Place 2 or 6 drops of oil into inlet 3.Check and replace O-ring or seal 4.Replace damaged air nailer internl parts |
| Air nailer does not operate well: can not drive fastener or operate slugishly |
1.Inadequate air supply 2.Inadequate lubrication 3.Worn or damaged air nailer's O-ring or seals 4.Exhaust port in cylinder head is blocked |
1.Verify adequate air supply 2.Place 2 or 6 drops of oil into air nailer's inlet 3.Check and replace O-ring or seal 4.Replace damaged internl parts |
| Tool skips fasteners |
1.Worn bumper or damaged spring 2.Dirt in front plate of the air nailer 3.Dirt or damage prevent fasteners from moveing freely in spray gun's magazine 4.Worn or dry air nailer's O-ring on piston or lack of lubrication 5.Cylinder cover air nailer's seal leaking
|
1.Repalce bumper or pusher spring 2.Clean drive channel on front plate 3.Air nailer's magazine needs to be cleaned 4.O-ring need to be replaced and lubricate 5.Replace sealing washer |
| Tool jams |
1.Incorrect or damaged fasteners 2.Damaged or worm driver guide 3.Air nailer's magazine or nose screw loose 4.Air nailer's magazine is dirty |
1.Change and use correct fastener 2.Check and replace the driver 3.Tighten the magazine 4.Clean the magazine |
Package included:
1XAir Staple Gun
More details:
